Product Description:
The GlassParency Ceramic Coating provides long-term protection and an enhanced appearance to the exterior surfaces of your vehicle. Our Ceramic Coating will leave your paint smooth to the touch by creating a hydrophobic, slick, and glossy surface.
Features & Benefits:
-
Protects paint from Water Spotting, UV Rays, Chemical Stains & Contaminants
- Ultra-Hydrophobic
- Easily wipe away dirt, grime and other contaminants
- Acts as a "sacrificial" layer that takes the beating of daily abuse to protect your paint
- Extreme Slickness and Gloss
- Size: 50 ml
Product Durability:
- Single Layer: 3-4 Years
- 2 Layers: 5 Years
- We recommend seasonal maintenance using the Boost Multi-Use Sealant to maintain product durability
PRODUCT APPLICATION
*Note: Ceramic Coatings require proper paint preparation and correction prior to application for the best results.
PREP:
- Prior to coating application, wash, prep, and correct the paint to remove any contaminants, imperfections, or residual chemicals
APPLICATION:
- Apply 6-8 drops of coating to the microfiber applicator pad.
- Start with the top surfaces of the vehicle (hood/roof) and then move to the sides of the car to avoid creating accidental blemishes in the uncured coating
-
Working in sections, wipe the coating onto the paint in smooth, straight lines from the front of the car toward the back
- Once applied to a section, wait 5-15 minutes (depending on temperature and humidity) until the coating flashes and becomes "tacky". Then inspect the coating for high spots and level them out using a microfiber towel or buffing pad.
- Once the entire vehicle has been coated and leveled, the coating will continue to cure for the next 24 hours and should not come in contact with any caustic or acidic substances such as detergents or bird droppings
- If the coating comes in contact with any of these contaminants before it's fully cured, just spray the Boost Silica Sealant and wipe the surface clean with a clean microfiber cloth.
MAINTENANCE:
- The coating will continue to harden for the next 10-14 days until it reaches its fully cured hardness. Continue to avoid caustic/acidic substances during this time.
- In the event that your vehicle has any dust, debris, or contaminant build-up during this time, a rinse with clean water and a gentle hand wash using the S2 PH Neutral or S3 Silica Soap is recommended
- Continue to maintain the effectiveness of your coating by using only PH Neutral soaps to avoid breaking down the coating with harsh detergents
- Maintain shine and hydrophobic properties over time with Boost Silica Sealant
